Reply To: Going from 3d printing to first cuts

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC Going from 3d printing to first cuts Reply To: Going from 3d printing to first cuts

#25198

Levi Blaney
Participant

Good news, the bit can easily handle that super fine MDF. I cut at 1.1mm DOC at 30k RPM’s with ease. Might be able to do a little more. Bad news is my table top was so off, that cutting the spoilboard flat created so much dust I decided not to cut a pocket for my mirror and just set it on top of the spoilboard and find a way to attach it. The good news I should be up and printing this weekend.

https://www.amazon.com/gp/product/B0093C1YNI/ref=oh_aui_search_detailpage?ie=UTF8&psc=1