Reply To: Estlcam with experimental Arduino Mega2560 / Ramps 1.4 support

New Home Forum Software Development Estlcam with experimental Arduino Mega2560 / Ramps 1.4 support Reply To: Estlcam with experimental Arduino Mega2560 / Ramps 1.4 support

#25375

Matt
Participant

@vicious1

I asked you because you put settings for ESTLCAM on the first page so i assumed you have tested it for a period of time and i was wondering how you were able to sustain 150mm/s….

It’s not a pronlem anymore, like i said i reduced it to 90mm/s and everything is woking this way.

I alreday moved the machine with repetier before switching to estlcam and everything was working good but again it means nothing because following your guide the contols are limited to 3600mm/min wich equals 60mm/S. So at 90mm/S i am above your recommending settings for repetier host.
So that’s why i was wondering how you could get ESTLCAM work at 150mm/s ???

@billbranan

I am runing Nema 17 2A with DRV8825 steppers at 0.71V and a power supply of 12 volts and 20 amps. A really standard and conservative setup.