Reply To: Image2Gcode – Free Raster Image Laser Engraving Software – Modified for MPCNC

New Home Forum Software Development Image2Gcode – Free Raster Image Laser Engraving Software – Modified for MPCNC Reply To: Image2Gcode – Free Raster Image Laser Engraving Software – Modified for MPCNC

#25394

Neil
Participant

Without knowing your setup (im assuming it is pretty stock as you say you followed the instructions). I would recommend following the instructions as presented by Jason here. I was having issues similar to yours prior to throwing in a few additional lines of code in the header. http://www.vicious1.com/laser-engraving-mirrors/
Hopefully, this will get you on the right path. Otherwise, good work man looks like the laser is working just fine (once you figure out your slight hang up).
Neil