Reply To: Electronics..

New Home Forum Mostly Printed CNC – MPCNC Advice – MPCNC Electronics.. Reply To: Electronics..

#25408

Bill
Participant

If you bought the parts here the resistor should have had a couple of connectors on it that plug into the pins sticking up from the RAMPS. If you didn’t get the parts here you should put the correct female connectors on to match those pins. You can also use a two socket connector with wires and solder the resistor to the wires. The key is to simulate a temperature so you don’t have to tweak the software to work in a non 3D print environment.