Reply To: Azteeg X3 Pro

New Home Forum Mostly Printed CNC – MPCNC Advice – MPCNC Azteeg X3 Pro Reply To: Azteeg X3 Pro

#25483

Matt
Participant

Steve, welcome to the club. I’m using an Azteeg X3 (non-pro model) from a previous 3d printer build I caniballized for the MPCNC build and it works great so you shouldn’t have issues because of that.

I’m using Ryan’s Marlin build and only had to edit some steps per mm settings for my Z (I’m using an 8mm lead screw instead of the imperial sized one) and had to invert a couple of axis direction as is normal when you wire the motors quick and then figure out they’re not turning the direction you wanted…

I haven’t tried playing with any lasers yet so I can’t offer any advice there but I know a lot of the guys on this board have and any advice they give would translate directly to the Azteeg board (it’s really just a suped up/cleaned up ramps/arduino combo).