Reply To: Estlcam with experimental Arduino Mega2560 / Ramps 1.4 support

New Home Forum Software Development Estlcam with experimental Arduino Mega2560 / Ramps 1.4 support Reply To: Estlcam with experimental Arduino Mega2560 / Ramps 1.4 support

#25504

Christian Knuell
Participant

Hi,

the base_frame.dxf file uses blocks – this is something Estlcam sometimes messes up, especially if there are blocks within blocks.

If you open it in LibreCAD, select all, click “Tools -> modify -> explode”, press enter and save again Estlcam will open it correctly.

Christian