Reply To: Choice of rotary tools

#2716

Ryan
Keymaster

I did edit the speed, accel, and jerk settings. I will upload the new firmware when I do another proper test cut.

If you are feeling froggy here is what I had in there.

#define DEFAULT_AXIS_STEPS_PER_UNIT {200,200,4535.44,760*1.1} // default steps per unit for Ultimaker
#define DEFAULT_MAX_FEEDRATE {9000, 9000, 150, 25} // (mm/sec)
#define DEFAULT_MAX_ACCELERATION {600,600,90,800} // X, Y, Z, E maximum start speed for accelerated moves. E default values are good for Skeinforge 40+, for older versions raise them a lot.

#define DEFAULT_ACCELERATION 600 // X, Y, Z and E max acceleration in mm/s^2 for printing moves
#define DEFAULT_RETRACT_ACCELERATION 600 // X, Y, Z and E max acceleration in mm/s^2 for retracts

// Offset of the extruders (uncomment if using more than one and relying on firmware to position when changing).
// The offset has to be X=0, Y=0 for the extruder 0 hotend (default extruder).
// For the other hotends it is their distance from the extruder 0 hotend.
// #define EXTRUDER_OFFSET_X {0.0, 20.00} // (in mm) for each extruder, offset of the hotend on the X axis
// #define EXTRUDER_OFFSET_Y {0.0, 5.00} // (in mm) for each extruder, offset of the hotend on the Y axis

// The speed change that does not require acceleration (i.e. the software might assume it can be done instantaneously)
#define DEFAULT_XYJERK 4 // (mm/sec)
#define DEFAULT_ZJERK 0.4 // (mm/sec)
#define DEFAULT_EJERK 5.0 // (mm/sec)