Reply To: Estlcam with experimental Arduino Mega2560 / Ramps 1.4 support

New Home Forum Software Development Estlcam with experimental Arduino Mega2560 / Ramps 1.4 support Reply To: Estlcam with experimental Arduino Mega2560 / Ramps 1.4 support

#29246

Brian
Participant

@ Steve. Use the PP I have attached for Vectric software.

I ended up resetting my stepper voltages, and triple checking my threaded rod and making sure it was lubbed with a lightweight oil. Fingers crossed..>So far so good. Ive done several 3d cuts that were 2+ hours without issue.

Attachments:
  1. Marlin_mm.zip