Reply To: Z-axis Still giving me a problem after everything

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC Z-axis Still giving me a problem after everything Reply To: Z-axis Still giving me a problem after everything

#29538

Matt
Participant

Quick followup.

took my Z axis off and scrubbed my threaded rod good with a nylon brush then lubricated it with a little mineral oil on a rag. I ran the same test as before manually sending gcode from Repetier host and even increased the speed and I couldn’t get it to hang up so now I am wondering could this have just been sawdust gumming up my threaded rod? I also feel like there is no way that was my only problem if it was even a problem, but it does run smoother now.