Reply To: How to wire linked stepper motors to Ramps

New Home Forum Mostly Printed CNC – MPCNC Advice – MPCNC How to wire linked stepper motors to Ramps Reply To: How to wire linked stepper motors to Ramps

#29641

John
Participant

So I’ll just have to test out all the motors and their connections to make sure everything is rotating the right way. I had a feeling this was going to be the answer but I was hoping there might be an easier way.

Thanks again for the help.

Additional important question I have while looking at the Z assembling instruction I noticed the tool mount seemed to be flush with the bottom of the pipes. I couldn’t tell if that is correct. I bring this up since I noticed my universal mount from thingiverse wasn’t flush with the bottom. Is that an issue? And could it be compensated with by the universal tool mount attachment?