Okay, I have a problem. For the 3rd time now I’m getting disconnects. The first two times I was running from the sd card. Thought the first time I lost an axis, so I checked all the wiring and zip tied the connectors together. They were taped before. Second time it did it, still from the sd card, so I redid the gcode. Third time I’m trying from my laptop and it’s done it again. Laptop this time said it disconnected. The first two times it just started cutting random directions, this time it just stopped, still ruined the cut, since it reset my zeros. I have the ramps running off a ups, and the router and shop vac running before the ups, so they shouldn’t be inducing any funkyness to the ramps. I can run the whole code without anything running and it finishes no problem. Any ideas?