Reply To: Firmware Differences

#29800

WarHawk8080
Participant

Worked for me first try, I got a Ramps board w/ screen drivers and end stops kit from banggood, compiled it up…screen was blank…went thru the configuration.h found those two // for full graphics display, removed them…recompiled, uploaded and viola…like a boss

vicious1 makes it easy even this knuckle dragging Marine could understand! Awesome!

I do have to go thru and set my drivers for 1/16 step though because I only have the A4988 vs the drv8825 drivers

But it’s more or less just divide everything by 2
for 1/32 steps
– #define DEFAULT_AXIS_STEPS_PER_UNIT {200,200,4535.44,200} (16T 5/16, use this http://www.prusaprinters.org/calculator/)
for 1/16 steps
– #define DEFAULT_AXIS_STEPS_PER_UNIT {100,100,2267.72,100} (16T 5/16, use this http://www.prusaprinters.org/calculator/)

Even 3D printed a nifty little case for it
http://www.thingiverse.com/make:314889

For help with Kris’s question…ran across this in reprap forums
http://forums.reprap.org/read.php?4,634909

Hope that helps