Reply To: Home button in Repetier, moving x and y without power, lcd not doing much

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC Home button in Repetier, moving x and y without power, lcd not doing much Reply To: Home button in Repetier, moving x and y without power, lcd not doing much

#29810

Zach T
Participant

1) Did you buy everything from here?
Yes.

a)If you didn’t or changed some things please don’t leave out any details and include what firmware you flashed.

I didn’t change anything. I assumed it came pre-flashed with the correct firmware.

2) Are you using end stops?

No.
a)If so please disconnect them.

3) Mac or PC?

PC Windows 10.

4) Include a picture so obvious errors might be spotted.
Attached. The cable on the right is my laptop power cable.

It says Vicious and has the logo when I power it on. My previous post has listed exactly what I purchased. The ip only shows up when the pc is hooked up.

I’ve attached two pictures. I tried to catch the Vicious logo, but missed it and ran out of time before work. I’ll take another picture this evening when I have more time. You’re seeing the screen right after the Vicious logo and the main screen. The x, y, and z alternate with ? indicating it’s not communicating I’m guessing.