Reply To: Inconsistent Cuts

#29862

gbiski
Participant

Hello Neil and Martin ,

Thanks for your help.

Neil I have all settings according to Ryans updated settings.
But all my codes have this feed rate of F2100 whatever my settings are…
Maybe I am doing something wrong but I cannot figure out what….

Martin reducing to 1/3 your z speed you mean on Estlcam to put F(z)=1mm/sec instead of F(z)=3mm/sec ?
Anyway I think that I am already in 1/16 step mode as I jumpered the mode 2 jumper on ramps so I’am in the following situation:
Low Low High 1/16 step