Reply To: How to set (relative?) home position?

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC How to set (relative?) home position? Reply To: How to set (relative?) home position?

#29867

Ryan
Keymaster

The home button is actually “move in the negative direction until you hit and endstop”, it is not “move to 0,0,0”

Either use Jens method, or I just rest my arduino or have it pre programmed into my gcode through the fusion post processor.

RC8 is not available on the site at this time? Recheck your firmware.

You can move in the negative direction with my firmware.