Reply To: Fusion 360 & post processor

New Home Forum Software Development Fusion 360 & post processor Reply To: Fusion 360 & post processor

#3089

WorkerDrone
Participant

Wanted to start a thread on post process for fusion360. I’m starting with just getting the post process to output gcode that repeitier host can work with. So far you still have to strip out everything above the start comment and strip off the trailing space at the end of the gcode. I’ll work on stripping out all of the unused commands at some point.
Check out my video of 360Fusion post process in action. https://youtu.be/zEXSNLUjagM