Reply To: Marlin/RAMPS patch to use extruder drivers as additionnal X+Y drivers

New Home Forum Software Development Marlin/RAMPS patch to use extruder drivers as additionnal X+Y drivers Reply To: Marlin/RAMPS patch to use extruder drivers as additionnal X+Y drivers

#3494

Ryan
Keymaster

Thanks, I looked at it for about 10 minutes….wasn’t in the mood for code yesterday. So I rewired it instead to clean it up a bit.
You think I will still be able to do this since I use the dual head code? I need the the PWN for the second head as the heater controller but use the extra driver port for the z axis. I saw in your code you disabled the E1 commands but I wasn’t sure if that would disable the D9 port as well. I will fire it up in a few minutes and see if I need to look into this some more.

Thanks for offering. If I dig into in I’m sure I will have more questions