Reply To: Changing Bits in Middle of Cut – Pre-pocketing

New Home Forum Software Development Changing Bits in Middle of Cut – Pre-pocketing Reply To: Changing Bits in Middle of Cut – Pre-pocketing

#3608

SteveC
Participant

Are you using an LCD controller or Repetier Host? In “theory” you should be able to use the Move commands in either GUI to lift Z so that you can make the change and it should still maintain it’s origin reference. Of course you have to be very careful not to move the steppers or they will be off by that much. I say in “theory” because I have not tried this 🙂 Let us know if this does not work.

Steve