Reply To: Banggood laser – IT WORKS!

New Home Forum Mostly Printed CNC – MPCNC Advice – MPCNC Banggood laser – IT WORKS! Reply To: Banggood laser – IT WORKS!

#39283

dkj4linux
Participant

GremlinRC, over on my FliteTest needle-cutter thread, shared his design for a shroud to enclose a similar 3.5 watt laser head from Banggood. I think it’s a little larger than the one you are looking at, and it’s not a shark, but it may give you ideas…

http://forum.flitetest.com/showthread.php?24251-Cutting-foam-sheets-with-a-needle!&p=320795&viewfull=1#post320795

We also played around quite a bit with air-assist… here’s my version installed on a 2′ x 2′ MPCNC

20170725_080925

20170725_080937

In action