Reply To: Jeffeb3's Low Rider Build

New Home Forum LowRider Your Builds – LowRider Jeffeb3's Low Rider Build Reply To: Jeffeb3's Low Rider Build

#39561

Ryan
Keymaster

No series?! worth the time.

Yesterday I started trying to push my lowrider, 2 hours of cutting and I was getting board. I found the belts stretching if I went to fast. I looked at thicker belt. It is way more expensive, and the pulleys and idlers are as well. The 6mm gt2 is dirt cheap from printers in mass production, the bigger setup is at least 3x’s as much if not more. As soon as I get the sand table part on the printer I am going to try and double up the belt, if that doesn’t work I am going to stack them face to face. Two 6mm belts should be stronger than a 8mm or at least as strong as a 10mm right? Two belts will also always be in slightly different tensions so that could be a good thing as well.