Reply To: Canuck MP3DP

#39658

Ralph
Participant
Do you have a first layer photo?

Nope, it’s hard to get a good pic of the first layer because of the cooling fan shroud. I raised the head by .2 and printed the same print (20×20) cube. This print did come of the PEI (and I always let it cool so the bed is at room temp) a bit better but did not pop off. I had to use the spatula again to get it off. The good news is that the cube was almost perfect 20.2 x20.2 and square. Here’s a video if this print, if u zoom in u can see the first layer.