Reply To: Mini Rambo Case?

New Home Forum Mostly Printed CNC – MPCNC Advice – MPCNC Mini Rambo Case? Reply To: Mini Rambo Case?

#39821

geodave
Participant

This is what I came up with so far. I shortened the length of the assembly by 20mm since the graphics display is so much shorter than the other display, but will probably make another version the same length as my original design because it looks like the USB cable might be difficult to get in there unless you take the end cap off or cut a hole in the end cap. I had to raise the height of it about 3/4″ for the taller graphic controller.

1 user thanked author for this post.