Reply To: Repetier Z problem

New Home Forum Mostly Printed CNC – MPCNC Advice – MPCNC Repetier Z problem Reply To: Repetier Z problem

#40012

Dalton Porter
Participant

Make sure your stepper connectors are not loose.  I had the molex connectors taped together, but it wasn’t good enough – occasional loose connection caused a Z issues.  On advice from the forum, I put a small zip tie around the connectors to keep them tight.  That issue was cured.

 

REF:  https://www.vicious1.com/forum/topic/z-axis-gone-bad/#post-29716