Reply To: Odd behavior. Offsetting layers horizontally while running .nc file

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC Odd behavior. Offsetting layers horizontally while running .nc file Reply To: Odd behavior. Offsetting layers horizontally while running .nc file

#4452

Ryan
Keymaster

Turns out a lot of people were trying to over drive there z axis, way too fast. the new firmware limits this. This could very well be your problem. May speed is 8.7mm/s with a low accel on the z. the other axis are 197mm/s.