Reply To: Up and running!




Thanks for the link mate, but I’m an Australian resident. I purchased a couple of cheap router bits from Bunnings (similar to your Lowes stores) and will experiment with them until my proper end mills arrive. What depth do you cut when you flatten your spill board? I’m very new to milling and am looking for some recommended feed rates, speeds, and depths to cut?


I spotted your Makita mount first, and liked the look, but sadly I need an IE version for my machine. I’ll experiment with joeskilton’s mounts, and if they prove too weak I’ll just design some different ones in Fusion360 (which is my new favorite software, SOOOO powerful and simple to use). Your MPCNC looks great, I like the wooden legs. I almost went this rout, didn’t (and still don’t) like the design of the recommended feet.