Reply To: Software Chain for Laser Cutting

New Home Forum Software Development Software Chain for Laser Cutting Reply To: Software Chain for Laser Cutting

#5686

Leo69
Participant

Ryan:

So are you still planning to add a laser to your machine? If so, will it be Jtech or will you buy a Nichia 2.8w laser module and use a generic driver? I’m asking because I’d like to see more “poor man’s” solutions for an MPCNC laser add-on. If you’re planning to do this and document it then that’s awesome but if not then I’ll try to get it done. Only thing is that I don’t use Ramps on my MPCNC so I’d be able to demonstrate how good/equivalent the cheaper 2.8w laser works but wouldn’t be able to create a how-to for wiring,software, etc.. What do you think?.