Reply To: Feed rates and depth of cut

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC Feed rates and depth of cut Reply To: Feed rates and depth of cut

#5835

Tomi Hautala
Participant

Got it working now, dont know what was wrong but did same thing than yesterday and now it slowed down.
made my first cut out and just a hair of chatter at 17mm/sec 0.5mm deep.
need to adjust the belts and tune the bearings a bit, also made alignment tool for the tubes
camaros z axis rigid add on helped abit

More questions, how can i make it cut the inside first?