Reply To: Z endstops?




About Z axis and these Z endstops, something is not clear to me. Min endstop (for homing)should be downside /on the table, and then the positive move of z would be up?

Or Z endstop min should be on close to the lower part of z tube for example, switching Home when Z goes up, (as on picture joined) and the positive move of Z would be down?

As it’s both Printing (work moves z up) and Milling (work moves Z down), I’m a little confused here…

Anyway, it’s start to work really fine, i’ll send more pics and vids 🙂