Reply To: CNC building report

New Home Forum Mostly Printed CNC – MPCNC Your Builds – MPCNC CNC building report Reply To: CNC building report

#6161

Filipe Campos
Participant

Hi,

Make some slow progress, only have some time each day after work..
New progress done:
– I have fixed the ramps box under the table and the lcd box on top.
– replaced the testing tube feets with the final one (17cm each).
– X and Y endstops installed and tested.
– installed the X, Y motor cables, still not tested because of the min temp error. I will in the future add an sensor temperature to check the temp inside the ramps box and configure to reset the ramps when the temp will be superior to 55ºC. I will put the motor cable connector inside the tube and add an printed tube cover.
-still printing the Z axis, there are lot of piece. I only print one piece at the end of each day… it is missing 4 piece to print to finish the Z.