Reply To: I need some help with ESTLCAM and Repetier to try to figure out my Z-Axis Woes

New Home Forum Software Development I need some help with ESTLCAM and Repetier to try to figure out my Z-Axis Woes Reply To: I need some help with ESTLCAM and Repetier to try to figure out my Z-Axis Woes

#6205

Leo69
Participant

I don’t know anything at all about Repetier so I’m not sure what happens when numbers change from black to red? Try manually jogging the Z axis until the tool tip is touching the top of the material and then send a G92 Z0 command through you gcode sender. This should set you Z axis to 0, then try running your program.