Reply To: MPCNC 2.8w $100 laser add-on complete

New Home Forum Mostly Printed CNC – MPCNC Your Builds – MPCNC MPCNC 2.8w $100 laser add-on complete Reply To: MPCNC 2.8w $100 laser add-on complete

#6340

Leo69
Participant

Thanks Karl. I shot lots of video during the tuning and set up so i could prepare a BOM and walkthrough guide . Hopefully I’ll have time to post it some time this week.

The drivers can be found all over eBay for about $8. Laser module is $70. A 12v 3amp power supply is needed but if you already have 10amps or better then you can just tap into the Ramps board for that. Heatsink was $4.

1 user thanked author for this post.