Reply To: Estlcam firmware + Arduino Uno + Protoneer CNC shield

New Home Forum Software Development Estlcam firmware + Arduino Uno + Protoneer CNC shield Reply To: Estlcam firmware + Arduino Uno + Protoneer CNC shield

#6986

Jon
Participant

The Pressure is on Joe;o) I just ordered the setup you mentioned above based solely on your recommendation and link. I hope it was right;o) (I did get the 4 driver setup). While I have the RAMPS setup, I would MUCH rather have a streamlined all in one setup as you describe in the above post. I figure its a $35 risk;o) While I am not new to computers, I am new to CAD/CAM so I want as easy entry as possible. Hope we can collaborate together.

Thanks,

Jon