Reply To: Fusion 360 & post processor

New Home Forum Software Development Fusion 360 & post processor Reply To: Fusion 360 & post processor

#7519

Rob
Participant

hello,

ive been using the v6 marlin firmware for 2 designs.
but both times i had the same issue. everything is working fine. but suddenly the router does not retract far enough. so it will just go through the design.
in my fusion program it does not show the trails it takes, but after post processing and in repetier-host. it shows some weird cuts through the object.

is this issue known. and what can to to find resolve this?

i’ve added a picture. with the result.