Reply To: Pipes too loose on printed parts

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC Pipes too loose on printed parts Reply To: Pipes too loose on printed parts

#7630

Ash Sav
Participant

I had the same issue running the 608zz, 1st I got some 6082rs for testing and all was good, then got 50 of the zz due to been a tad cheaper and every thing was loose as a goose, measured the OD same same, but the internal diameter was a bee’s dick off so the bearing was loose on the bolt, updated all to the 2rs’s and every thing is now nice and tight