Reply To: LaserWeb – fully functional Laser Cutter Controller which runs over http

New Home Forum Software Development LaserWeb – fully functional Laser Cutter Controller which runs over http Reply To: LaserWeb – fully functional Laser Cutter Controller which runs over http

#7642

Bryan
Participant

*Disregard in my previous comment about fixing the comm issues. They are still haunting me >.<*

I installed a fresh Jessie Raspbian image on a new card and went through the same setup again, and I am running into the same problems. It finds the port the Mega is on, but doesn’t fully connect to it. On my list is to try stock Marlin among other configurations. I’ll keep my progress updated here.