Reply To: Estlcam firmware + Arduino Uno + Protoneer CNC shield

New Home Forum Software Development Estlcam firmware + Arduino Uno + Protoneer CNC shield Reply To: Estlcam firmware + Arduino Uno + Protoneer CNC shield

#7727

Ash Sav
Participant

just looking through the config.h and we have DEFAULT_MAX_FEEDRATE {195, 195, 8.7, 25} // (mm/sec) so I guess 195 mm/sec
estlcam is asking for ipm for maximum feed rate, I ran this through a online calculator http://www.conversion-website.com/speed/millimeter-per-second-to-inch-per-minute.html
and got a result of 195 millimeters per second = 460.629921263 inches per minute this seems a tad fast, am I on the correct path, or way off the money…