Reply To: Estlcam firmware + Arduino Uno + Protoneer CNC shield

New Home Forum Software Development Estlcam firmware + Arduino Uno + Protoneer CNC shield Reply To: Estlcam firmware + Arduino Uno + Protoneer CNC shield

#7740

Leo69
Participant

195 is the correct number. Keep in mind that this is a max travel speed limited by the firmware but your cutting speed will be much slower and defined by you based on the tool and material used and the depth of each cutting pass that you set in your cam software.
The195 is max speed for rapid travel moves and in most cases these moves will be fairly short and your acceleration/jerk settings will not allow any axis to reach full travel speed over a short distance. If you’re just jogging the machine around manually you’ll see that it is very capable of zipping around at a quick pace.