Reply To: Steppers Stalling VERY easily/ No power or torque

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC Steppers Stalling VERY easily/ No power or torque Reply To: Steppers Stalling VERY easily/ No power or torque

#7787

justindp
Participant

Using the one on this page:

Marlin Firmware


https://www.vicious1.com/wp-content/uploads/2015/12/B16_32-LCD-112515.zip

I open your file but can’t get it to run because it keeps wanting to heat extruder. I have tried editing the code and doing a dry run but apparently I’m missing something

edit* Found the .nc test file. moves the same. my next test I think is going to be to take the power supply off my other cnc router table and try running the motors a little hotter.