Reply To: Steppers Stalling VERY easily/ No power or torque

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC Steppers Stalling VERY easily/ No power or torque Reply To: Steppers Stalling VERY easily/ No power or torque

#7824

Ryan
Keymaster

If the z is not stronger it is a stepsize, wiring, firmware, or friction issue. If it is stronger double check each stepper by themselves to make sure you don’t have a bad one, then triple check to make sure you are wired in parallel not series, and wired correctly.