Reply To: Image2Gcode – Free Raster Image Laser Engraving Software – Modified for MPCNC

New Home Forum Software Development Image2Gcode – Free Raster Image Laser Engraving Software – Modified for MPCNC Reply To: Image2Gcode – Free Raster Image Laser Engraving Software – Modified for MPCNC

#8321

Noname007
Participant

Image size is about 60x73mm.
Resolution 300DPI, estimated time in pronterface was 13minutes but took 42minutes to do.
And done just with standards, not the optimized rastering, this will come in the next testrun.
Will also fiddle with the threshold to check how it works.
But as said, so far I am impressed.
Guess it means you have beaten Picengrave on all accounts here 😉

Not sure if you can spot the bright areas left of the chin and under the chin – they are actually toally black in the original image but for some reason did not get any laser power during the engraving, like being reversed out.