Reply To: Fusion 360 & post processor

New Home Forum Software Development Fusion 360 & post processor Reply To: Fusion 360 & post processor


Drew Rogge

Has anyone managed to use Fusion 360 to generate gcode to cut Allted’s logo from his DXF file. I can use the dxf to create pockets in the surface of a block but the CAM part of Fusion refuses to create the pocketing gcode. The big difference I see when using Allted’s dxf vs another dxf that I created is that on the one that works the entire pocket turns blue when I select the edge whereas on the logo just the edge turns blue.

I haven’t given ESTLCAM a try as I’m looking for a non-Windows solution.

Thanks for any help,