Reply To: Nick's Build

#8519

nerdyrcdriver
Participant

About to loosen everything up, hopefully it helps without having to re print the middle end.

Strange about the different sizes,. If it is the same thread size I would expect it to have the same OD. Guess not.

Edit: Dang, I knew this would suck. Because I ran the stepper extensions through the conduit I can’t take the center assembly all the way out. I decided I would do everything right the first time and soldered the extensions. I didn’t print the solderless mounts because I was planning on plasma cutting the motor mounts anyway. Guess I can’t change those out either unless I want to undo my soldering work.