Reply To: Current limit Stepper drivers drv8825

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC Current limit Stepper drivers drv8825 Reply To: Current limit Stepper drivers drv8825

#9686

Jeffeb3
Participant

I was using the arduino mega with RAMPS board to do it. They are disabled by default, so I went into the menu, told them to move (prepare -> move axis -> move 1mm -> Move Y) and then I let it just sit there at that position. This was with only one motor, but I don’t think it should matter.