0.9 degrees Stepper motors Setup

New Home Forum Mostly Printed CNC – MPCNC Advice – MPCNC 0.9 degrees Stepper motors Setup

This topic contains 1 reply, has 2 voices, and was last updated by  Ryan 8 months, 3 weeks ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #26396

    gbiski
    Participant

    Hello,

    I just finished the build of the mpcnc and now I will connect the electronics and the ramps 1.4.
    My steppers are 0.9 degrees, thus 400 steps per revolution.
    My Stepper Motor Drivers are the DRV8825.
    In order to use the pre-configured marlin firmware (B16_32_8mm-fullG-112515 – Full graphic LCD firmware) as is do I need to configure the stepper at 1/16 steps ?

    Thanks for the help

    #26411

    Ryan
    Keymaster

    That is an older firmare, I suggest using the Rc7.

    You can use any step rate you want other, even full stepping if you don’t need the full accuracy.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.