25.4 build with metric fasteners?

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC 25.4 build with metric fasteners?

This topic contains 2 replies, has 3 voices, and was last updated by  srcnet 10 months, 1 week ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
  • #20815


    Would it be possible to use the metric fasteners list with the 25.4 build, considering it’s based on imperial measurements?

    Also: Ryan, is there any chance you would be interested in selling *just* the fasteners as a set? I’d rather order online than spend 2 hours looking for them at Home Depot and not being sure I got the right kind… And I’d rather if I have to order them online the money goes in your pocket instead of Home Depot’s 🙂


    Derek P

    M8 and 5/16″ machine screws are almost identical in diameter. They can be used interchangeably.



    It’s at the bottom of this page http://www.vicious1.com/blog/parts/

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.