3d Milling

This topic contains 5 replies, has 4 voices, and was last updated by  Martin DB 8 months, 3 weeks ago.

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • #28652

    Brian
    Participant

    Ok folks. Ive asked my fair share of questions and there will be more yet to come. But I wanted to show a couple things Ive been up to. Heres a few 3D Milling jobs Ive done lately. You can see the “N” and “A” on the plaque are not as deep as the letters. There ver a very slight bow in the board that really showed itself in the letters. This was a Z Axis test anyway.

    #28656

    Martin DB
    Participant

    Looks really good. Wich software are you using for desing and for CAM?

    #28657

    Zeenon
    Participant

    Looks great!!!! How long did each one take once you started the gcode?

    Z

    #28658

    Ryan
    Keymaster

    They look great all finished and spiffy!

    #28668

    Brian
    Participant

    I downloaded vectric aspire. That software takes things to a whole new level. Believe it or not the beer 30 took as long as the rings plaque. Roughly 2 hours worth of finishing work with a 1/8 ball nose bit. But each one took 3 bits to complete.

    Now…..If I could get this post processor thing figured out so Im not puckered it will decide to plunge into a nice piece of wood.

    #28672

    Martin DB
    Participant

    Thank you very much.

Viewing 6 posts - 1 through 6 (of 6 total)

You must be logged in to reply to this topic.