52mm spindle holder?

Tagged: 

This topic contains 1 reply, has 2 voices, and was last updated by Profile photo of Tyler Bletsch Tyler Bletsch 8 months, 1 week ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #13883
    Profile photo of autox3d
    autox3d
    Participant

    I got a couple 300 watt air cooled spindles in the shop, is there a 52 mm size spindle holder available?

    I found they are quite a lot lower cost than the routers at less than $100 each delivered by DHL from China.

    ERll collet and 11 bit size adapters.

    #14845
    Profile photo of Tyler Bletsch
    Tyler Bletsch
    Participant

    I wrote a customizable tool holder model in OpenSCAD, but I didn’t end up testing it because I found a Thingiverse model for my exact tool (a crappy Harbor Freight cutout tool). See here if you want to give it a shot.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.