#6-32 Screw Locations

This topic contains 3 replies, has 3 voices, and was last updated by  Jono Skipwith 1 year, 1 month ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #16348

    Jono Skipwith
    Participant

    Hi All
    I’m about to buy all the nuts and bolts and I would like to know where it’s all being used, just to start thinking about the assembly process. The parts list calls for 57 x #6-32 X.75, M3.5 x 20mm metric equivalent . I’m going to use M4’s as M3.5 are too hard to find.

    I can’t see where all 57 of these are used – I get up to 47. Can somebody tell me what I’m missing from the list below please? Much appreciated.

    Quantity
    Corner Assembly
    Bottom_Corner 1
    Lock_Corner 1
    Top_Corner 4
    Foot Bottom 1
    ————————————-
    7 x 4 = 28

    RollerMount 2
    ————————————-
    2 x 4 = 8

    Z Axis
    Tool Mount 4
    Z-Lower 2
    Z-Motor 2
    Pineapple Coupler 2
    ————————————-
    1 x 10 = 10

    Nut Lock 1
    ————————————-
    28 + 8 + 10 + 1 = 47 total

    #16353

    Jason
    Participant

    Possibly was the 57 included the screws and nuts for the tool mount itself? I think there is 5 on the left and 5 on the right. Otherwise your numbers look right to me.

    #16365

    Ryan
    Keymaster

    Yup, plus ten for the 660 mount. I figure no mount will need more than that so that is what I include.

    #16383

    Jono Skipwith
    Participant

    Thanks Guys! Much appreciated.

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.