Advice sought

This topic contains 2 replies, has 2 voices, and was last updated by Profile photo of Martin Brandon Martin Brandon 2 weeks, 2 days ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #31340
    Profile photo of Martin Brandon
    Martin Brandon
    Participant

    How critical are the tool mount hole dimensions in the z axis tubes? If they are a little bit out does it matter?

    #31346
    Profile photo of Bill
    Bill
    Participant

    Not really, best if they’re centered and the right diameter but as long as the screws fit and snug up you’re good.

    #31351
    Profile photo of Martin Brandon
    Martin Brandon
    Participant

    Ok thanks Bill.

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.