Another lowrider, chris893

New Home Forum LowRider Your Builds – LowRider Another lowrider, chris893

This topic contains 4 replies, has 4 voices, and was last updated by Profile photo of Ryan Ryan 3 months, 3 weeks ago.

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #26608
    Profile photo of chris893
    chris893
    Participant

    Laser cut parts
    https://goo.gl/photos/Sy1JsWGHfrMkrpZM7

    Prints
    https://goo.gl/photos/pLCuZQknoyKQgFw27
    https://goo.gl/photos/9dsAa19SMSqn3HmC7
    https://goo.gl/photos/aMxt5RR1xoPS1ijW8
    If you look closely, you can see a slightly warped motor mount in the top right corner. I didn’t notice until assembly. I reoriented the parts and they printed fine, no warping. The room my printer is in is poorly insulated and has drastic temp swings.

    I’m always happy when I wake up to a successfully completed print
    https://goo.gl/photos/Pw6382WH2BBApaym9

    After this print I ran into issues with my printer. The printer wouldn’t home x from sd or usb port. Turns out that one of the wires on the x endstop had broken off at the soldering point. I don’t have pics and wouldn’t dare post a pic of my poor in place soldering job, its working again though. Hang in there little printrbot, a MP3DP is on the way…

    Main components assembled:
    https://goo.gl/photos/onNj33DR8dh16Dgm6
    Now if I could just get the time to build the table and cut some steel….

    #26613
    Profile photo of Ryan
    Ryan
    Keymaster

    Oh My God!!!! That is sexyyyyy. I can’t wait to see more.

    #26647
    Profile photo of Martin DB
    Martin DB
    Participant

    Sweet!

    #26656
    Profile photo of Matthew
    Matthew
    Participant

    This is beautiful! I was hoping to be able to use acrylic as well, since our laser cutter at work can cut 1/4″ Acrylic, but not 1/4″ plywood. I’m probably about a third to half of the way through printing parts.

    Looking forward to seeing more updates!

    Matt

    #30807
    Profile photo of Ryan
    Ryan
    Keymaster

    Any updates on this? I am kinda itching to see this thing assembled.

Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic.